Baby Monitor,Indoor Home Baby Monitor,Camera Baby Monitor,Wireless Video Baby Monitor Shenzhen Zuomi Technology Co., Ltd. , https://www.bkvis.com Gem Biogas Fermentation (Mast Fermentation is Best for Fermentation Aids)
During the biogas fermentation process, poor management can lead to several issues, such as slow gas production, low output, or crust formation. To address these problems, using biogas fermentation aids like Gembio can significantly enhance gas yield and make the process more efficient. This effectiveness is due to the unique properties of Gumbol Biogas Fermentation Aid.
Gumbol contains essential nutrients and trace elements that support the growth and activity of methanogens, the key microorganisms responsible for biogas production. These trace elements help stimulate the methanogens, encouraging faster reproduction. At the same time, the product increases enzyme activity, speeding up the breakdown of complex organic materials like cellulose. The added nutrients also help maintain a healthy microbial environment, supporting the growth of beneficial bacteria.
Additionally, the inclusion of an adsorbent in the formula increases the contact area between the microbes and the raw materials, enhancing efficiency. The heat generated during adsorption also helps raise the temperature of the methanogens, promoting faster gas production within the digester.
The recommended dosage is 200–250 grams of Gumbol per cubic meter of digester. For standard fermentation tanks with capacities of 4, 6, 8, and 10 cubic meters, the basic amounts are approximately 2, 3, 4, and 5 bags, respectively. When using a new digester, mix the raw materials and Gumbol evenly before adding them. For older digesters, remove some slurry from the outlet and flush the Gumbol through the inlet several times to ensure even distribution.
New digesters can see their start-up time reduced by over 50%, while older systems can experience a significant boost in both gas output and production rate. Normally, after adding the fermentation aid, the material should begin producing gas quickly. If no improvement is observed within a week, first check if the mixture was properly distributed. If not, repeat the injection process through the feed inlet. Also, inspect the system for leaks and take corrective actions if needed. For more details, visit the official website or contact customer support.