First, the horizontal trough mixer instructions and precautions Second, horizontal trough mixer maintenance instructions
1. Before use, perform a dry run test. Before the test, check the firmness of all the connecting parts of the horizontal trough mixer, the amount of lubricating oil in the reducer and the integrity of the electrical equipment, and then close the main switch. Pass the power supply and test the air run.
2. The empty running test requires an item-by-item test. It can only be put into production if no abnormal sounds, high heat of the bearing, high temperature of the reducer, etc. are found.
3. If you need to shovel the material of the tank wall during operation, apply bamboo and wood tools, and do not use your hands to avoid accidents.
4. If the machine vibration is abnormal or abnormal noise is detected during the use of the horizontal trough mixer, stop it immediately.
5. The load of the mixer should not be too large. Generally, it is measured by the load of the motor. The heavy load current when mixing with a 380V motor is not more than 6 amps. If the load exceeds the load, the mixing capacity should be reduced immediately.
6. The shaft seals at both ends of the mixing paddle should be kept clean to avoid blackening and deterioration of the material. The square holes at the two ends of the mixing tank should be open, and should not be blocked, so as to prevent back pressure and allow dirt to penetrate. The shaft center makes the material in the tank black and deteriorate.
7. Managers must be familiar with the technical performance, internal structure, and control structure of the horizontal trough mixer. Do not leave the work site during operation to prevent damage to the machine parts, so as to ensure safe production.
1. Regularly check the machine parts 1-2 times a month. Check whether the movable parts such as the worm gear, the worm, the bearing and the shaft seal are flexible and wearable. The defects should be repaired in time so that the groove mixer can be used normally.