Note for horizontal ink wheel printing and sealing machine: 1. Before use, check whether the power supply voltage meets the requirements, whether the wiring is firm, and whether the ground wire is connected properly. 2. Check if the lubrication of each transmission component is good and inject a proper amount of lubricating oil. 3. When the machine is shut down, the heater switch must be disconnected first, so that the input and output part can still run for 15-20 minutes, and the machine can be stopped, in order to extend the life of the sealing tape, the grinding wheel and the printing wheel. Technical parameters Power consumption 600W
Sealing speed 0-13m/min
Sealing width 0mm 15mm
Film thickness 0.02mm 0.08mm
Maximum load 5kg
Number of prints 0 20
Temperature control range 0°C 300°C