Every time the milking parts are finished, the parts that the milk passes through should be cleaned in time. Cleaning method: first rinse with water, then put into hot detergent (temperature 70 ° C, containing 1% alkali), wash with a brush, and finally clean with 80 ° C hot water, dry for use.
Cleaning and checking the rubber sleeve in the rubber sleeve should be removed and cleaned, but it should be prevented from being deformed due to excessive water temperature. At the same time, it is necessary to check whether the rubber sleeve is intact and it is found to be leaking. It should be replaced immediately.
After checking the milk collector, after cleaning, check whether the rubber gasket is in good condition and whether the small holes on the four walls are clear to the atmosphere.
Prevent the glass test tube from damaging the glass test tube and the inlet switch on the milk tank cover. Care should be taken during the cleaning process to avoid damage and no air leakage after assembly.
Repair the pulsator pulsator and vacuum hose once a week, and check that the rubber film of the pulsator is intact and that the small holes in the wall are clear to the atmosphere. After assembly, adjust the pulsation frequency of 40-70 times per minute for use. Refueling of the pulsator is carried out according to the supplier's requirements.
Timely replacement of the milk tube should be done in time to replace the milk tube. Otherwise, milking is difficult due to its poor elasticity. On the other hand, any small cracks on the surface will leave milk scale, which will provide conditions for the reproduction of bacteria.
Check the milk pump check valve once a week. If the check valve diaphragm breaks, the air will enter the milk pump and there should be a milk pump check valve for use.
Check the vacuum regulator, sensor and vacuum pump belt once a month. Wipe the valve, seat, etc. of the vacuum regulator with a damp cloth. Clean the sensor filter with soapy liquid, dry it and then install it. Press the belt with your thumb should have 1.25 cm. If the tension or belt is worn or damaged, it should be replaced in time. After replacing or adjusting the belt, check whether the two wheels are in a straight line.