Manual Traction Device,Lumbar Traction Bed,Multiduty Lumbar Traction Bed Medco Medical Equipment Co., Ltd. , http://www.sghospitalbed.com
Pneumatic tool operation and maintenance of basic points
Pneumatic tool operation and maintenance basic points 1. The correct generation of gas supply system: inlet pressure at the tool inlet (non-air compressor outlet pressure) is generally 90PSIG (6.2Kg/cm^2), too high, too low Impairs the performance and life of the tool. The air inlet must contain enough lubricant so that the air motor in the tool is fully lubricated (place a white paper on the tool exhaust to see if there is oil, normally it is oily). The intake air must not contain moisture, and it is not appropriate if the air is not air-dried. 2. It is not allowed to remove the parts of the tool and operate it afterwards. This will cause the tool to be damaged in addition to affecting the safety of the operator. 3. If the tool is slightly faulty or cannot be used after it has been used, do not continue to use it. Check it immediately. 4. Periodically (about once a week) Check and maintain the tool, add grease (Grease) to bearings, etc., and add oil to the air motor. 5. Use all kinds of tools and be sure to follow all safety regulations and instructions for use. 6. To use the proper tools to work, tools that are too large are prone to work injuries, and tools that are too small can easily damage the tools.